Using InPower BPU, when would an initial calibration file be installed on a DCS?

Using InPower BPU, when would an initial calibration file be installed on a DCS?

• A. When a new DCS is connected
• B. If no previous capture file exists
• C. After every restart
• D. Upon user request

Answer: (B)

The initial calibration file is intended as a one-time setup to establish baseline calibration when there is no prior calibration data. InPower BPU uses a capture file to store existing calibration data; if no capture file exists, loading the initial calibration provides the DCS with valid baseline values for accurate measurements. If a capture file already exists, that file contains the calibrated data from prior operation, so reloading the initial calibration would overwrite or conflict with trusted data. It isn’t tied to every restart or to a manual request in normal operation; it specifically applies when there’s no previous capture file to establish a starting point.

The initial calibration file is intended as a one-time setup to establish baseline calibration when there is no prior calibration data. InPower BPU uses a capture file to store existing calibration data; if no capture file exists, loading the initial calibration provides the DCS with valid baseline values for accurate measurements. If a capture file already exists, that file contains the calibrated data from prior operation, so reloading the initial calibration would overwrite or conflict with trusted data. It isn’t tied to every restart or to a manual request in normal operation; it specifically applies when there’s no previous capture file to establish a starting point.